Pool cleaners like the polaris 360 operate off of the pool s equipment relying on the flow of water from the pump to the pool in order to move.
Polaris pool cleaner back up valve troubleshooting.
Ensure that the back up valve is functioning properly.
Luckily this is one of the easier polaris pool cleaner troubleshooting methods.
Simply lift the cleaner from the pool s base and also check to determine whether all the wheels move.
The back up valve is a small canister located in the middle of the cleaner s feed line.
Stain algae scale remover.
Polaris does not back up.
However if the back up valve is working and the tail is moving back and forth but the wheels aren t moving it sounds like a broken belt.
The polaris 360 pool sweep automatically runs over the pool bottom picking up debris and dirt.
Back up valve the pool cleaner could be.
Will this product work.
When the polaris 360 gets stuck in a corner or otherwise hampered by objects in the pool the sweep s.
Lift the back up valve out of the water then turn the pool cleaner on and observe the cleaner s jet.
Depending on the water pressure that is reaching the pool sweep head review the following steps to determine the possible solution to the problem.
The back up valve must be installed 14 20 inches from the cleaner and the water opening where water shoots out of must be facing the cleaner and not away from it.
Fixing my polaris back up valve.
Anyway if the back up valve is working and the tail is waving back and forth but the wheels aren t turning sounds like a broken belt.
If more than 32 rpm unscrew the pressure relief valve 46 to decrease water flow.
Water should exit the jet and then the jet should turn off.
My pool pump was off for about 6 months and my pool got really bad and.
Simply lift the cleaner from the bottom of the pool and check to see whether all the wheels turn.
Fortunately this is one of the easier techniques for polaris pool cleaner troubleshooting.
These valves tend to fail often.
Verify the back up valve 54 is cycling.
The first step in troubleshooting your polaris 380 pool cleaner is to determine if you are getting good water pressure at the head of the pool cleaner.
Or install the red restrictor disc to decrease water flow even more.
